Class1 114356 - ITL 4LT with 1-wire and CAN COM 113739 11 Manual de usuario descargar pdf (Pagina 18)

FORM-ENG-0018 REV A 05-27-03

PAGE

17 of 22

SUITABLE FOR EXTERNAL DISTRIBUTION

OPERATION MANUAL

DATE 10/23/2007

PRODUCT GROUP ITL P/N 12V: 113739 ; 24V: 114378 REV 1.20

607 NW 27th Ave

Ocala, FL 34475

Ph: 352-629-5020 or 1-800-533-3569

Fax : 352-629-2902 or 1-800-520-3473

PRODUCT

4 LIGHT INTELLI-TANK DISPLAY WITH 1-wire and CAN

BY AMS

DATASHEET P/N:114356 - UNCONTROLLED IN PRINTED FORMAT - PRINTED: 10/24/07

7.5.5. CAN method, pump sensor module and 1 remote

System configured with CAN communication method. This example shows one remote display (using pump

sensor module address) following the indications of the Class 1 Pump Sensor Module.

7.5.6. Terminating resistor requirement (CAN communication)

A terminating resistor (120 Ohm) is required on both ends of the CAN bus for proper operation. Only two

terminating resistors are allowed on a CAN bus.

Terminating resistor p/n DT06-3S-P006

CAN “Y” connector p/n DT04-3P-P007

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Class1 114356 - ITL 4LT with 1-wire and CAN COM 113739 11 Manual de usuario Pagina 18